EC Engineering Analog Electronics Online Test, Online Mock Test
Electronics and Communication Engineering Analog Electronics Online Test
0 of 11 questions completed
Electronics and Communication Engineering Analog Electronics Online Test. Electronics and Communication Engineering Question and Answers in English. The Electronics and Communication Engineering Full online mock test paper is free for all students and Very Helpful for Exam Preparation. Electronics and Communication Engineering Online Mock test for Electronics and Communication Engineering Analog Electronics Topic. Here we are providing Electronics and Communication Engineering Analog Electronics Online Test Series in English. Check Electronics and Communication Engineering Mock Test Series 2019.
This paper has 30 questions.
Time allowed is 30 minutes.
The Electronics and Communication Engineering online Mock Test Exam is Very helpful for all students. Now Scroll down below n click on “Start Quiz” or “Start Test” and Test yourself.
You have already completed the quiz before. Hence you can not start it again.
Quiz is loading...
You must sign in or sign up to start the quiz.
You have to finish following quiz, to start this quiz:
0 of 11 questions answered correctly
Time has elapsed
You have reached 0 of 0 points, (0)
- Not categorized 0%
|Table is loading|
|No data available|
- Question 1 of 11
Electronics and Communication EngineeringCorrectIncorrect
- Question 2 of 11
For a base current of 10 μA, what is the value of collector current in common emitter if βdc = 100CorrectIncorrect
- Question 3 of 11
Which of the following oscillators is suitable for frequencies in the range of mega hertz?CorrectIncorrect
- Question 4 of 11
An RC coupled amplifier has an open loop gain of 200 and a lower cutoff frequency of 50 Hz. If negative feedback with β = 0.1 is used, the lower cut off frequency will beCorrectIncorrect
- Question 5 of 11
The load impedance ZL of a CE amplifier has R and L in series. The phase difference between output and input will beCorrectIncorrect
- Question 6 of 11
If an amplifier with gain of – 1000 and feedback factor β = – 0.1 had a gain change of 20% due to temperature, the change in gain of the feedback amplifier would beCorrectIncorrect
- Question 7 of 11
In a BJT circuit a pnp transistor is replaced by npn transistor. To analyse the new circuitCorrectIncorrect
- Question 8 of 11
To protect the diodes in a rectifier and capacitor input filter circuit it is necessary to useCorrectIncorrect
- Question 9 of 11
In a CE amplifier the input impedance is equal to the ratio ofCorrectIncorrect
- Question 10 of 11
For a system to work, as oscillator the total phase shift of the loop gain must be equal toCorrectIncorrect
- Question 11 of 11
An amplifier has a large ac input signal. The clipping occurs on both the peaks. The output voltage will be nearly aCorrectIncorrect